1999-2010 GM 2.25" Diameter Flex Pipe - 5.50" Length 3-Bolt
1999-2010 GM 2.25" Diameter Flex Pipe - 5.50" Length 3-Bolt
K2 Industries
Part #
K2-4410-UNV-006-EXH
UPC #
Couldn't load pickup availability
Product Description
Product Description
1999-2010 GM 2.25" Diameter Flex Pipe — 5.50" Length 3-Bolt
A flexible exhaust connector that absorbs engine vibration and thermal stress without cracking. This 2.25" diameter flex pipe spans 5.50" and bolts directly to your factory mounting points with three bolts on each end. Built to handle the movement between your engine and exhaust system.
Key Features
- Braided stainless steel construction - Resists corrosion and handles repeated flex cycles without failing.
- 3-bolt connection at each end - Bolts straight to factory exhaust flanges with no welding or modification needed.
- Absorbs drivetrain movement - Isolates vibration transfer to the frame and suspension, reducing noise and stress on exhaust hangers.
Specs
- Diameter: 2.25"
- Length: 5.50"
- Connection: 3-bolt flange on each end
- Configuration: Flex pipe assembly
Whats Included
- 1x Flex pipe assembly (5.50" length, 2.25" diameter)
Frequently Asked Questions
Do I need bolts to install this?
The 3-bolt flanges are ready to bolt to your factory exhaust ports and mid-pipe, but hardware is not included. You'll need six bolts (three per flange) — check your service manual for the correct size and torque spec for your vehicle.
Can I reuse my factory bolts?
Most factory exhaust bolts are one-time use and should be replaced when you disconnect and reconnect. Grab a fresh set of exhaust bolts in the correct size before installation — they're inexpensive and designed to handle the thermal cycles.
What if my exhaust has surface rust or corrosion?
Wire-brush the factory flange surfaces where the flex pipe will bolt on. Make sure both mating surfaces are clean and flat for a solid seal. The flex pipe itself is stainless steel braided, so it resists rust — but the connection needs a clean surface.
