2.75" to 3.00" 45 Degree Reducer Silicone Hose 3-Ply Blue
2.75" to 3.00" 45 Degree Reducer Silicone Hose 3-Ply Blue
K2 Industries
Part #
K2-1477-UNV-006-TSARK
UPC #
Couldn't load pickup availability
Product Description
Product Description
2.75" to 3.00" 45 Degree Reducer Silicone Hose 3-Ply Blue
Stepped silicone reducer hose bridges two different diameter intake or cooling lines with a 45-degree angle. 3-ply construction handles boost and coolant systems without kinking. Blue finish matches common custom intake setups.
Key Features
- 45-degree elbow geometry - Routes hose past tight engine bay obstacles without sharp bends that crush airflow.
- 3-ply silicone construction - Resists heat cycling, oil, and coolant degradation better than single-wall rubber.
- 2.75" to 3.00" step - Handles transitions between different coupler sizes in one fitting.
Specs
- Material: Silicone
- Configuration: 45-degree reducer elbow
- Inlet diameter: 2.75"
- Outlet diameter: 3.00"
- Ply rating: 3-ply
- Color: Blue
- Quantity: 1 hose
Whats Included
- One 2.75" to 3.00" 45-degree silicone hose
Frequently Asked Questions
Do I need clamps to secure this hose?
Yes. Standard worm-gear or T-bolt hose clamps work on both the 2.75" and 3.00" ends. Hardware is not included — use clamps rated for your system pressure.
Can I use this for both intake and coolant lines?
Silicone handles both applications. Confirm your system pressure stays within silicone limits — boost systems above 20 psi may need reinforced hose. Test fit before final installation.
Will this hose need any prep or sealing before I install it?
No prep needed. Wipe the barbed ends clean and dry, then slide onto your inlet tubes and clamp tight. Apply clamps to the thicker barb sections for best grip.
