2014-2017 Infiniti QX60 Wheel Hub & Bearing Assembly - FWD Models
2014-2017 Infiniti QX60 Wheel Hub & Bearing Assembly - FWD Models
K2 Industries
Part #
K2-11301-INF-006-TSARK
UPC #
Couldn't load pickup availability
Product Description
Product Description
Wheel Hub & Bearing Assembly — FWD
Direct-fit wheel hub assembly engineered for front-wheel-drive models. Combines the spindle, bearing races, and mounting flange in one sealed unit to eliminate wobble, noise, and steering play. Pre-assembled and ready to bolt on.
Key Features
- Sealed bearing cartridge - Eliminates play and road noise at the wheel
- Factory mounting interface - Bolts to existing knuckle without modification
- Complete assembly - No separate bearing service required; swap the whole unit
Specs
- Configuration: Front axle, FWD only
- Assembly type: Sealed cartridge bearing with integrated flange
- Condition: New
Whats Included
- Wheel hub and bearing assembly
Frequently Asked Questions
Do I need new bolts to install this?
Reuse your existing knuckle bolts if they're in good condition. If any are stripped or damaged, you'll need replacements rated for your vehicle — check your service manual for torque spec and bolt grade.
Can I press this onto my old axle shaft?
This assembly is a complete unit; the axle shaft passes through the bearing cartridge. Before install, inspect the shaft for scoring or corrosion where the bearing rides. Light surface rust is fine, but deep pitting or wear will cause premature bearing failure — replace the shaft if needed.
What if the wheel still has play after I install it?
Loose play usually means the knuckle bolts weren't torqued correctly or the axle nut is under-tightened. Remove the wheel, grab the tire at 3 and 9 o'clock, and test again. If play persists, verify all fasteners are tight per your service manual, then test-drive before troubleshooting further.
