3-Ply Silicone Hose 1.00" to 1.25" Reducer Black/Red
3-Ply Silicone Hose 1.00" to 1.25" Reducer Black/Red
K2 Industries
Part #
K2-1324-UNV-006-TSARK
UPC #
Couldn't load pickup availability
Product Description
Product Description
3-Ply Silicone Hose 1.00" to 1.25" Reducer — Black/Red
Reinforced silicone reducer hose steps down from 1.00" to 1.25" diameter with three-ply construction. Built for coolant, vacuum, and intake applications where reliable flex and heat resistance matter. Black exterior with red interior makes routing and diagnostics straightforward.
Key Features
- Three-ply silicone core - Resists cracking and hardening under heat cycles better than single-wall tubing
- Stepped diameter - Tapers from 1.00" to 1.25" so you can join different hose sizes without adapters
- Dual-color design - Black outside shields from UV; red inside simplifies tracing coolant paths during troubleshooting
Specs
- Material: Silicone
- Configuration: 1.00" to 1.25" reducer
- Construction: 3-ply reinforced
- Exterior Color: Black
- Interior Color: Red
Whats Included
- 1x 3-Ply Silicone Reducer Hose
Frequently Asked Questions
Do I need clamps to install this hose?
Yes. This hose requires clamps on both the 1.00" and 1.25" ends. Spring clamps or worm-drive clamps work depending on your space constraints — measure twice before ordering clamps.
Can I use this for a radiator or heater hose setup?
It's rated for coolant flow, vacuum lines, and intake applications where temperatures and pressures stay within silicone limits. If you're unsure whether your system's pressure or temp matches, check your vehicle's cooling diagram first.
Will this hose need prep before I connect it?
Clean the barbed fitting ends and hose bores with a clean cloth to remove dust. No adhesive or sealant is needed — mechanical clamp pressure does the job if you tighten properly.
