88-00 Honda Civic / 94-01 Acura Integra K20 Swap Exhaust Header Gasket
88-00 Honda Civic / 94-01 Acura Integra K20 Swap Exhaust Header Gasket
K2 Industries
Part #
K2-4571-HON-006-TSARK
UPC #
Couldn't load pickup availability
Product Description
Product Description
K20 Swap Exhaust Header Gasket
Seal your K20 header to the block without exhaust leaks. This gasket handles the thermal cycling and pressure that comes with engine swaps. Direct fit for K20 applications on Civic and Integra platforms.
Key Features
- Engineered for K20 mounting surfaces - Seals the header-to-block interface on swap builds without custom fitment
- Thermal stability - Built to hold under sustained heat and pressure cycles
- Swap-ready thickness - Cut to match K20 header port spacing
Specs
- Construction: Hard composite gasket material
- Configuration: Single header gasket
- Condition: New
What's Included
- Header gasket (qty 1)
Frequently Asked Questions
Do I need to prep or clean the mounting surface before installing this?
Yes. Clean both the header flange and block surface with a wire brush or gasket scraper to remove any old gasket material or carbon buildup. A clean, flat surface helps the seal seat properly and prevents leaks.
What hardware do I need to bolt the header down?
This gasket comes alone — you'll need header bolts and washers. Refer to your K20 header manufacturer's spec sheet or service manual for the correct bolt size and torque sequence. Most K20 headers use M10 or M11 bolts.
Can I reuse this gasket if I pull the header off later?
No. Once a composite gasket is compressed and heated, it loses its seal integrity. Plan to replace it every time you remove the header. Reusing it risks exhaust leaks and oil seepage.
