Oil Drain Line Flange Kit with Gasket and Bolts 10 AN Fitting
Oil Drain Line Flange Kit with Gasket and Bolts 10 AN Fitting
K2 Industries
Part #
K2-1144-UNV-006-OLK
UPC #
Couldn't load pickup availability
Product Description
Product Description
Oil Drain Line Flange Kit with Gasket and Bolts — 10 AN Fitting
Complete flange kit for 10 AN oil drain lines, ready to bolt straight to your block or turbo housing. Includes pre-matched gasket and fastener set so you're not hunting down hardware. Hard panel construction rated for sustained oil pressure cycles.
Key Features
- Pre-matched gasket - Seals at the flange face without guesswork or additional purchases.
- Bolt set included - Fasteners are matched to flange specs so you can assemble immediately.
- 10 AN port - Standard turbo and aftermarket block drain sizing for LS, RB, and forced induction platforms.
Specs
- 10 AN fitting configuration
- Gasket and bolts included
- One flange assembly
Whats Included
- Oil drain line flange
- Gasket
- Bolt set
Frequently Asked Questions
Do I need to apply sealant under the gasket?
The gasket alone seals the flange face. No additional sealant is required — hand-tighten the bolts evenly and you're sealed. Over-tightening can crush the gasket, so work methodically around the flange.
Will this kit work with my turbo or block setup?
10 AN is the standard drain port for most turbo housings and LS/RB block adapters. Verify your drain port size before ordering — if it's different, this kit won't mate.
Can I reuse the gasket if I remove the flange later?
Replace the gasket every time you break the seal. Oil exposure and bolt cycles compress the gasket permanently, so a new one costs less than a slow leak into your engine bay.
