Simucube Dual Power Supply Mount

Get Two Power Supplies Off the Floor

The Simucube Dual Power Supply mount fixes two power bricks to your rig instead of leaving them loose underneath it. So cables stop getting pulled and the bricks stop sliding around.

It holds two units in one mount. Therefore a wheelbase and an ActivePedal can share a single bracket rather than needing two.

Check Your Model Number First

This fits power supply model GST360A48-C6PGR. Because Simucube has used more than one supply across generations, the number on the brick matters more than which base you own.

If you have a newer Simucube wheelbase and an ActivePedal that both use GST360A48-C6PGR, this mount takes both. However, if yours reads differently, check the single mount instead.

What's Included

• Top and bottom 3D printed mount
• 2x M5 T-nuts and bolts

The T-nuts drop into standard aluminum profile. As a result, fitting takes a few minutes with a hex key and no drilling.

Made by Apex Sim Racing

We design and print these in house in New Jersey. So if you need a mount for a power supply we do not list yet, get in touch and we will see what we can do.

Why Buy From Apex Sim Racing

Apex Sim Racing has been building sim racing hardware since 2019. In short, backed by 25,000+ orders shipped.

Complete Your Setup

Only have one power supply? The Single Power Supply Mount covers that. Running a Simucube 2 Ultimate? Use the Ultimate Power Supply Mount.