Universal 2.25" Aluminum Intercooler Piping Kit - 8PC Red 90D
Universal 2.25" Aluminum Intercooler Piping Kit - 8PC Red 90D
K2 Industries
Part #
K2-4347-UNV-006-TSARK
UPC #
Couldn't load pickup availability
Product Description
Product Description
Universal 2.25" Aluminum Intercooler Piping Kit — 8PC Red 90D Elbows
Eight 90-degree aluminum pipe sections in bright red, designed for custom intercooler plumbing on turbo and supercharged builds. 2.25-inch diameter tubing lets you route boost lines with precision and clean aesthetics. Pre-bent elbows eliminate the need for mandrel bending equipment and custom fabrication.
Key Features
- 90-Degree Elbows — Pre-bent angles reduce fabrication time and ensure consistent line routing.
- 2.25" Diameter — Compatible with standard intercooler hose and clamp sizing for most turbo and supercharger kits.
- Bright Red Anodize — Corrosion-resistant finish that won't fade or chip during engine bay cycling.
Specs
- Material: Aluminum
- Configuration: Eight 90-degree elbows, 2.25" diameter
- Finish: Red anodized
- Piece Count: 8
What's Included
- Eight aluminum 90-degree elbows (2.25" diameter)
Frequently Asked Questions
Do these elbows work with stock intercooler hoses and clamps?
Yes. The 2.25-inch diameter is standard for most aftermarket turbo and supercharger piping kits. You'll use conventional T-bolt or worm-gear clamps to secure hose to the aluminum pipe sections.
Will I need to seal these connections or apply any coating before assembly?
The red anodize is factory-applied and requires no prep. Assemble dry with clamps at each joint—intercooler piping doesn't need sealant since boost pressure is contained by the hose clamps themselves.
Can I cut or modify these elbows to fit my engine bay?
Aluminum cuts easily with a bandsaw or angle grinder. If you're trimming length, deburr the ends to prevent hose damage. Pre-bent angles are rigid—cutting or re-bending requires a mandrel bender.
